Instruction Manual

Advanced Programming 9-7
17. Test Fid 1 or click on Next.
> The Teach Window closes and the Edit Pattern Skip Info dialog box opens.
18. Select
Skip Pattern If Mark Not Found.
19. Click on
Teach Skip Mark.
> A Teach Window opens asking you to select the method for teaching your skip mark.
20. Select
Model Finder.
21. Click on
Next.
22. Use the Position Controls to center the camera crosshairs on the dot slightly above and to the
left of where you taught the origin and fiducial.
23. Click on
Teach.
24. Test the skip mark or click on
Next.
> The Teach Window closes and you return to the Edit Pattern Skip Info dialog box.
25. Click on
OK to close the box.
> A message box opens indicating that the dispensing head is about to move to the
“Workpiece” origin.
> The dispensing head will move after your response.
26. Click on OK.
> The dispensing head moves to the origin of Workpiece.
27. Select
Lfill from the Pattern Name text box.
> A message box opens indicating that the dispensing head is about to move to the
Lfill
origin.
> The dispensing head will move after your response.
28. Click on
OK.
> The dispensing head moves to the origin of Lfill.
29. From the Program Commands toolbar, click on
Pattern.
30. Select
Pass Block.
> The Start Pass instruction dialog box opens.
> This is the command that allows you to re-use the fiducial and height sense information
for each pass, rather than perform the operation each time.
31. Enter 2 in the Number of passes text box.