Instruction Manual

9-6 Advanced Programming
To program the workpiece with L-shaped underfill patterns:
1. Perform a Programming Setup. (See the Setup and Configuration section of this manual.)
> Load the Tutorial Board to Side 2.
> Choose
Two Fiducials, and Learn Workpiece Angle first.
> For your fiducials, use the Model Finder method and program Fid 1 as the fiducial in the
lower left-hand corner (LLHC) and Fid 2 as the fiducial in the upper right-hand corner
(URHC) on Side 2 of the Tutorial Board.
2. In the Main Window, click on
Teach a Program.
3. Click on
to open a new file.
> Or click on File and select New.
4. Click on
Pattern on the Program Commands toolbar.
5. Select
Create Pattern.
6. Type
Lfill in the text box.
7. Select
One fiducial.
8. Activate the
Use Pattern Skip Mark feature.
9. Click on
OK.
> A Teach Window opens asking you to teach the pattern origin.
10. Use the Position Controls to center the camera crosshairs on the ULHC of the first flip chip
model in the top row of flip chip models.
> Teach the Origin exactly at the corner of the flip chip model. You do not use Chip Offset
until you are programming the lines.
11. Click on
Teach.
12. Click on
Done.
> You are now asked to select a method for teaching the fiducial.
13. Select
Corner Finder.
14. Click on
Next.
15. Teach Fid 1 of the pattern
Lfill at the same location as the Origin.
> Make sure that the ULHC of the Quadrant Model in the area below the video display is
highlighted. If it is not, click on it to highlight it.
16. Click on
Teach.