Instruction Manual

Installation 2-3
Installation Procedure
Most of the standard installation process is automated. You will be prompted to approve file locations
and accept defaults. Automatic backups are made for some files during installation.
Since FmNT is a true Windows software package, installing FmNT follows standard Windows
installation procedures.
CAUTION! This installation procedure should be performed by an application engineer,
Information Systems manager or computer programmer.
CAUTION! Do NOT attempt to install FmNT on Windows 95 or Windows 98.
To install FmNT:
1. If any Windows programs are running, close them.
2. Insert the FmNT CD-ROM into the CD drive of the dispensing system computer. The
installation procedure should launch automatically. If it does not, perform steps a through f
below. If the installation procedure does launch automatically, skip to Step 3.
a. Click on
Start in the lower left hand corner (LLHC) of the computer screen.
b. Select
Run from the Start menu.
c. Click on
Browse in the Run dialog box.
d. Locate the CD drive from the directory and double-click on it.
e. Locate the
Setup.exe file and double-click on it.
f. Click on
OK in the Run dialog box.
3. Select “Typical installation” unless otherwise instructed.
> Contact Asymtek Technical Support for help if necessary.
4. If you are asked to input the dispensing system serial number and/or model, you can find the
information on the tag on the back panel of the dispensing system. Enter the information
when requested.
5. If you are asked to insert the “Cal map” diskette, you can find the disk in a pouch located on
the inside of the lower front cabinet door.
> Contact Asymtek Technical Support for help if necessary.