Instruction Manual

Beginning Programming 8-15
15. Set the Dot Parameter Valve-On Time to 0.250 sec, and Dwell Time to 0.050 sec. Set all the
other parameters for
Type 2 to the same settings established for Type 1.
> This will adjust the
Valve-On Time and Dwell Time for Type 2 dots.
16. Click on
Apply.
17. Click on
OK.
18. Select
Dry Run from the Run menu.
> The dispensing head will move after your response.
> Watch to see the camera locate the position of the dots.
19. Select
Wet Run from the Run menu.
> Watch to see the dots dispensed.
> Examine the board, you should notice a difference in the size of the
Type 1 and Type 2
dots.
This concludes the tutorial on Dots.