Instruction Manual

8-10 Beginning Programming
23. Click on Done.
> A message box opens, indicating the calculated line speed for the newly created weight
control line.
24. Click on OK.
25. In the Programming Window, select
Edit Line Parameters from the Edit menu to open the
Line Parameters dialog box.
26. Set the Line Parameters for Line Type 1 to:
Pre-Move Delay Factor: 0.1
Down Speed: 2
Down Acceleration: 300
Dispense Gap: 0.015
Speed: (not used for weight control lines)
Shut-off Distance: 0.010
Suckback: 0.000
Dwell: 0.0
Backtrack Gap: 0.050
Backtrack Length: 0.040
Backtrack Speed: 2
Retract Distance: 0.100
Retract Speed: 2
Retract Acceleration: 300
27. Click on
Apply.
28. Click on
OK.
29. In the Programming Window, select
Dry Run from the Run menu.
> The dispensing head will move after your response.
> Watch to see the camera traverse the programmed lines. You may observe a difference in
dispensing speed for each line.
Help If you get an error message that the speed is too slow, re-check your line
parameters and try again. Refer to “Editing Lines” earlier in this chapter.
30. In the Programming Window, select
Wet Run from the Run menu.
> Watch as the lines are dispensed.
> Examine the board for quality and accuracy.
This concludes the tutorial on Weight Control Lines.