Instruction Manual

8-8 Beginning Programming
To program weight control lines:
1. Perform the Programming Setup procedure in the Setup and Configuration section of this
manual, then return here.
> Load Side 1 of the Tutorial Board.
> When you create the Workpiece, define the Workpiece Alignment.
> Choose
No Fiducials.
2. Click on
Dispensing Elements on the Program Commands toolbar.
> A Teach Window opens.
3. Click on
Weight Control Lines.
> Notice, as shown in Figure 8-3, that the Teach Window has additional text boxes below
the video display specifically for weight control lines.
Figure 8-3