Instruction Manual

8-4 Beginning Programming
Editing the Lines
If you were not satisfied with the lines dispensed, you can simply edit them. This exercise will teach you
how to edit existing lines in a program. For this exercise, you will shift the lines over and shorten them.
To edit the lines (shift them over and shorten):
1. From the
Edit menu in the Programming Window, select Edit Pattern.
2. Click on
Workpiece.
> The dispensing head will move after your response.
3. Place the cursor on
1 LINE in the program and double-click.
> A Teach Window opens.
4. Use the Position Controls to move the camera crosshairs to a new starting point on the first
line of the tutorial board.
5. Click on
Teach.
6. Use the Position Controls to move the camera crosshairs to the end point of the line.
7. Click on
Teach.
8. Repeat Steps 3 through 7 for the other two lines.
9. Click on
Done.
10. Select
Dry Run from the Run menu.
> The dispensing head will move after your response.
> Watch to see the program run with the lines shifted over and shortened.
11. Select
Wet Run from the Run menu.
> Watch as the lines are dispensed.
> Examine the board for quality and accuracy.
This concludes the tutorial on Editing Basic Lines.