Instruction Manual

7-12 Programming Basics

Item Description

1 Search Length

2 Projection Length

3 Caliper

4 Application Point

Figure 7 -4

Item Description

1 Multiple Calipers

Figure 7 -5

When using a single fiducial with Orthogonality Tolerance, FmNT calculates the angle of the corner

defined by the calipers. If the corner is within the

Orthogonality Tolerance, the part is considered

square and dispensing on the part will be performed. For example, if the

Orthogonality Tolerance is set

at 5, and the corner fiducial is determined to be 85-95 degrees, FmNT considers the part to be square.

However, if the corner fiducial is less than 85 degrees or more than 95 degrees, FmNT will issue an

Orthogonality Tolerance warning and you can choose to skip the part or redefine the fiducial.