User Manual

Setup and Configuration 6-37
Dispensing System
Home Position
Origin of
Workpiece (0,0)
Workpiece Angle
Workpiece
Workpiece
x-axis
x-axis
Dispensing
System
y-axis
Dispensing
System
Defined pojnts along
Workpiece x-axis
Workpiece
y-axis
Figure 6-14
5. Click on Configuration.
6. From the Configuration menu, select Setup Fluid Manager
Setup Fluid ManagerSetup Fluid Manager
Setup Fluid Manager to open the Fluid Manager
dialog box, shown in Figure 6-13.
7. Enter the information on the fluid you will be using for this tutorial (Hysol 4510 or
equivalent).
> The Pot Life should be documented in the material information data sheet.
> It is recommended that you disable Purge Maintenance for the tutorial
exercises. This means that the system will not automatically purge while in a
production run mode and will not purge during programming. Or, set the
option for over 900 seconds so that your programming runs are not interrupted
by automatic purging while running test programs.
8. Click on Save.
> FmNT takes you back to the Main Window.
9. Click on Teach a Program.
10. Select File
FileFile
File from the Programming Window menu bar.
11. Select Fluid Table
Fluid TableFluid Table
Fluid Table, and then Save As
Save AsSave As
Save As.
> Save the Fluid File as a <filename>.flu file. You will attach this file to
your program later.
12. Click on OK.
13. Place the Tutorial Board as follows, depending on the type of dispensing system
you have: