User Manual

Setup and Configuration 6-15
Initial Setup
Your system is initially configured and setup by an Asymtek representative. However, it
may be necessary or desirable to repeat some of the configuration routines to insure
programming accuracy.
?NOTE Initial Setup is not equivalent to a complete system re-installation
configuration and setup procedure. If your system requires re-installation,
please call Asymtek for assistance.
There are two optional Initial Setup procedures:
· Calculate Master Offsets (available on M-600 Series systems only)
· Valve Offsets (available on M-600 and M-2000 Series systems)
Both procedures perform all of the necessary setup functions. The main difference between
the two procedures is that Valve Offsets allows you to perform the entire process one step at
a time. Calculate Master Offsets walks through the entire process from start to finish.
?NOTE Even though both procedures perform all of the necessary setup functions,
they are not identical. It is recommended that you use Valve Offsets as your
setup procedure.
?NOTE If you change from one setup procedure to the other, it is recommended that
you exit FmNT and restart FmNT before performing the newly selected
procedure.
?NOTE Before performing either the Calculate Master Offsets or the Valve Offsets
setup procedure, you must first make sure that the Vision System has been
setup.