User Manual

6-10 Setup and Configuration
Figure 6-8
35. Click on the arrow next to the Heater (1
Heater (1 Heater (1
Heater (1 or 2)
2) 2)
2) box and select the type of heater
installed on your system.
> Heater 1
Heater 1Heater 1
Heater 1 refers to the left-most heater station on your system configuration.
Heater 2
Heater 2Heater 2
Heater 2 refers to the right-most heater station on your system configuration.
Each heater station needs to be active in order for you to be able to configure
it, and each heater station needs to be configured individually.
> Generally, the type of heater installed on your dispensing system is Anaphase.
If your dispensing system is not equipped with heaters, select (none)
(none)(none)
(none).
> Consult the Online Help for complete explanations of all options available in
this dialog box.
?NOTE Configuring the heaters is not the same as setting up the heaters.
Refer to Section 4–Heater Controls for heater setup instructions.
36. Click on OK.
?NOTE System Configuration is now complete and FmNT must be
restarted for all of the changes to take effect. Refer to
Section 3–Tour of Fluidmove for startup instructions.
37. In the Main Window, click on Exit.
This concludes the System Configuration procedure.