User Manual

Tour of Fluidmove 3-15
Process Toolbar
The commands associated with each icon on the Process Toolbar are identified below.
However, you will notice that FmNT toolbars have Tool Tips. As you move the cursor
over a button, a “tip” appears below the button, explaining its function. If a button is
greyed-out, that means that the command is not available at this point in the
programming session. The Wet/Dry Run Mode and Display Video buttons toggle to
change between the two modes.
Figure 3-11
Create a New
Program
Open a Program
File
Save Current
Program
Print Current
Program
Toggle Wet o
r
Dry Run Mode
Move Dispenser
to Home Position
Unload a Boar
d
Load a Board
Toggle Video
Display On or Off
Purge Valve
Cut Program Lines
Copy Program Lines
Paste Program Lines
Run Current Program
Pause Run After
Next Command
Stop Run at End
of Current Board
Run Program in Steps
A
bort Run
Measure Flow
Rate Command
Access Jog
Controls
Access Online
Help
Return to Main Window