User Manual

Tour of Fluidmove 3-9
Figure 3-5
Clicking on Dispenser, Conveyor 1 or Scale will bring up a Terminal Mode window. In the
Terminal Mode Window, you can type commands for the device. On M-600 Series
dispensing systems, the Dispenser and Conveyor both use Automove Control
Language (ACL) commands for communication. On M-2000 Series dispensing
systems, the Dispenser uses PMAC commands and the Conveyor uses ACL. The
Scale uses its own command language. For information on PMAC, ACL or Scale
commands, contact Asymtek Application Engineering.
?NOTE Dispensing systems equipped with dual-lane conveyors will have two
conveyor buttons in this window, one for each conveyor. Two heater
buttons may also be visible in this window, depending on system
configuration. The heaters are discussed in more detail in the Heater
Controls section of this manual.
è Click on Conveyor to see an example of the Terminal Mode window.
è Click on Exit
ExitExit
Exit to close the Terminal Mode Window and return to the Tools
Window.
è Click on I/O Test in the Tools Window.