User Manual

Tour of Fluidmove 3-3
User Interface
You will find that the FmNT user interface was designed to utilize the simplicity and
intuitiveness of Windows-based software. In this section, you will learn how to start
FmNT and you will visit all of the major windows and menus within the FmNT
environment.
Starting FmNT
The FmNT start-up procedure assumes that FmNT is already installed on your
computer, and that the computer is turned ON and running Windows NT.
?NOTE If your computer is not running Windows NT, consult your
Information Service Group.
To start FmNT:
1. Click on Start in the lower left-hand corner of your computer screen.
2. Select Programs
ProgramsPrograms
Programs from the Start menu.
3. Select ASYMTEK FMNT
ASYMTEK FMNTASYMTEK FMNT
ASYMTEK FMNT from the Programs menu.
4. Click on
to start FmNT.
> FmNT will now start. It will check to see that all the Input and Output
(I/O) devices for your dispensing system are communicating properly
with FmNT.
Do not press any keys or the mouse while FmNT is booting.
If you get any errors regarding the Conveyor, Dispenser, Heaters or
Vision System, refer back to Chapter 1 - Getting Started and check
the readiness of your dispensing system.