User Manual

Advanced Programming 9-17
47. Click on Teach.
48. Use the Position Controls to move the dispensing head to the URHC of the same
flip chip model.
> Use Chip Offset or reticles.
49. Click on Teach.
50. Click on Done.
51. From the Program Commands toolbar, click on Time.
52. Select Reset Multipass Timer
Reset Multipass TimerReset Multipass Timer
Reset Multipass Timer.
> This will start a new timer.
53. Place the cursor on the last
END PASS (for Pass 3) and click on Time in the Program
Commands toolbar.
54. Select Await Multipass Timer
Await Multipass TimerAwait Multipass Timer
Await Multipass Timer.
55. Type in 20 seconds and click on OK.
56. From the Program Commands toolbar, click on Dispensing Elements.
57. Click on Weight Control Lines.
58. Enter 80 mg in the Total Weight
Total WeightTotal Weight
Total Weight text box and select Line Style 1.
> This is the total weight to be dispensed at all the locations where this pattern
will be dispensed. In this case, four U-shaped lines around the four flip chip
models in Pattern 3 on the Tutorial Board.
59. Use the Position Controls to move the dispensing head to the ULHC of the first
flip chip model.
> Use Chip Offset or reticles.
60. Click on Teach.
61. Use the Position Controls to move the dispensing head to the LLHC of the same
flip chip model.
> Use Chip Offset or reticles.
62. Click on Teach.
63. Use the Position Controls to move the dispensing head to the LRHC of the same
flip chip model.
> Use Chip Offset or reticles.
64. Click on Teach.
65. Use the Position Controls to move the dispensing head to the URHC of the same
flip chip model.
> Use Chip Offset or reticles.
66. Click on Teach.
67. Click on Done.
68. From the File
FileFile
File menu, select Save As
Save AsSave As
Save As and type in multipas.fmw to save the file as
multipas.fmw.