User Manual

9-10 Advanced Programming
64. From the File
FileFile
File menu, select Save
SaveSave
Save and type in undrfil.fmw to save your program
as undrfil.fmw.
> Your program should look like this:
1 START PASS: FOR PASS 1
2 FIND SUBSTRATE HEIGHT: (x, y)
3 WEIGHT CONTROL:50.00, 1, ([x
1
, y
1
],[x
2
, y
2
], [x
3
, y
3
])
4 RESET MULTIPASS TIMER:
5 END PASS:
6 START PASS: FOR PASS 2
7 AWAIT MULTIPASS TIMER: 30 seconds(s)
8 WEIGHT CONTROL:30.000,1, ([x
1
, y
1
],[x
2
, y
2
], [x
3
, y
3
])
9 END PASS:
10 END
65. In the Pattern Name text box, select Workpiece.
> A message box opens indicating that the dispensing head is about to move to
the “Workpiece” origin.
The dispensing head will move after your response.
66. Click on OK.
67. Place the cursor on
END.
68. From the Program Commands toolbar, click on Process.
69. Select Measure Flow Rate
Measure Flow RateMeasure Flow Rate
Measure Flow Rate.
70. To set up for placing the pattern Lfill, click on Pattern on the Program Commands
toolbar.
71. Select Loop Block
Loop BlockLoop Block
Loop Block.
72. Type 2 in the Number of Passes
Number of PassesNumber of Passes
Number of Passes text box for the two L-shaped passes in Lfill.
73. Click on OK.
74. In the programming screen, place the cursor on
Next Loop.
75. Click on Pattern on the Program Commands toolbar.
76. Select Place Multipass Pattern
Place Multipass PatternPlace Multipass Pattern
Place Multipass Pattern.
77. In the Teach Window, select Lfill in the Available Patterns
Available PatternsAvailable Patterns
Available Patterns text box.
78. Use the Position Controls to move the dispensing head to the ULHC of the first
flip chip in the ULHC of Pattern 1.
79. Click on Teach.
The program wil
l
find a substrate
height at this X
Y
location
This is the L-
shaped line in
the first pass
Weight of Line
X
Y Locations
Defining Line 1
This is the
command to wai
t
until the 3
0
second timer has
expired before
going on to the
next comman
d