User Manual

Advanced Programming 9-7
19. Click on Teach Skip Mark.
> A Teach Window opens asking you to select the method for teaching your
skip mark.
20. Select Model Finder
Model FinderModel Finder
Model Finder.
21. Click on Next.
22. Use the Position Controls to center the camera crosshairs on the dot slightly above
and to the left of where you taught the origin and fiducial.
23. Click on Teach.
24. Test the skip mark or click on Next.
> The Teach Window closes and you return to the Edit Pattern Skip Info dialog
box.
25. Click on OK to close the box.
> A message box opens indicating that the dispensing head is about to move to
the “Workpiece” origin.
The dispensing head will move after your response.
26. Click on OK.
> The dispensing head moves to the origin of Workpiece.
27. Select Lfill from the Pattern Name text box.
> A message box opens indicating that the dispensing head is about to move to
the “Lfill” origin.
The dispensing head will move after your response.
28. Click on OK.
> The dispensing head moves to the origin of Lfill.
29. From the Program Commands toolbar, click on Pattern.
30. Select Pass Block
Pass BlockPass Block
Pass Block.
> The Start Pass instruction dialog box opens.
> This is the command that allows you to re-use the fiducial and height sense
information for each pass, rather than perform the operation each time.
31. Enter 2 in the Number of passes
Number of passesNumber of passes
Number of passes text box.