User Manual

8-24 Beginning Programming
5. Click on OK.
> A Teach Window opens asking you to teach the pattern origin.
6. Use the Position Controls to center the camera crosshairs on the ULHC of Flip
Chip 1 on the Tutorial Board.
> This will be the Origin of the pattern.
7. Click on Teach.
8. Click on Done.
> The Teach Window changes asking you to select a method for defining a
fiducial.
9. Select Corner Finder
Corner FinderCorner Finder
Corner Finder and click on Next.
> The dispensing head should still be centered on the ULHC of Flip Chip 1,
where you taught the pattern Origin. If it is not, use the Position Controls to
move it there.
> Notice the Quadrant Model, the green square in the area below the video
display. The ULHC of the Quadrant should be highlighted to indicate that this
is the corner you are going to teach. If the ULHC is not highlighted, click on
it to highlight it.
10. Click on Teach.
11. Test the fiducial for accuracy, or click on Next to continue.
> The Teach Window changes and you are asked to select a method for defining
the second fiducial.
12. Select Corner Finder
Corner FinderCorner Finder
Corner Finder and click on Next.
13. Use the Position Controls to center the crosshairs on the LRHC of Flip Chip 1.
> This will be the second fiducial.
> The LRHC of the Quadrant Model should be highlighted to indicate that this
is the corner you are going to teach. Click on it to highlight it.
14. Click on Teach.
15. Test the fiducial for accuracy, or click on Next to continue.
> The Teach Window closes and a message box opens indicating that the
dispensing head is “About to move to Reference Origin of Workpiece.”
16. Click on OK.
The dispensing head will move after your response.
17. In the Programming Window, select FCLine1 in the Pattern Name text box.
> A message box opens indicating that the dispensing head is “About to move
to Reference Origin of FCLine1.”