User Manual

Beginning Programming 8-23
Placing Patterns
Patterns, as explained in “Building a Program” earlier in this chapter, are essential building
blocks of complex dispensing programs for workpieces. In this exercise you will learn how
to create a simple dispensing pattern and place it on a workpiece at multiple locations.
For this exercise, you will create a simple L-shaped underfill pattern and place it on the
workpiece Tutorial Board. You will perform a wet dispense.
?NOTE If you are performing this tutorial during a new programming session,
review Chapter 6 - Setup and Configuration.
Estimated time to complete: 45 minutes.
To program and place a pattern:
1. Perform a Programming Setup.
> Load Side 1 of the Tutorial Board.
> When you create the Workpiece, define the Workpiece Alignment.
> Choose Two Fiducials.
2. From the Program Commands toolbar, click on Pattern, and select Create Pattern
Create PatternCreate Pattern
Create Pattern.
> The dialog box in Figure 8-7 opens.
Figure 8-7
3. Type in FCLine1 in the text box.
4. Select Two
TwoTwo
Two fiducials.
> Skip Marks are basically specialized fiducials and will be explained later in
Chapter 9 – Advanced Programming.