User Manual

8-10 Beginning Programming
8. Click on Teach.
9. Click on Done.
> A message box opens, indicating the calculated line speed for the newly
created weight control line.
10. Click on OK.
> The Workpiece Pattern program should look like this:
1 WEIGHT CONTROL: 20.000, 1,...
2 END
11. Repeat Steps 2, 3 and 4, and type in 25 mg for the next weight control line.
12. Move the camera crosshairs to the beginning of the next weight control line on the
Tutorial Board.
13. Click on Teach.
14. Move the camera crosshairs to the end of the line.
15. Click on Teach.
16. Click on Done.
> A message box opens, indicating the calculated line speed for the newly
created weight control line.
17. Click on OK.
18. Repeat Steps 2, 3 and 4, and type in 35 mg for the next weight control line.
19. Move the camera crosshairs to the beginning of the last weight control line on the
Tutorial Board.
20. Click on Teach.
21. Move the camera crosshairs to the end of the line.
22. Click on Teach.
23. Click on Done.
> A message box opens, indicating the calculated line speed for the newly
created weight control line.
24. Click on OK.
Weight of Line
Line Style