User Manual

Beginning Programming 8-9
To program weight control lines:
1. Perform the Programming Setup in Chapter 6 - Setup and Configuration.
> Load Side 1 of the Tutorial Board.
> When you create the Workpiece, define the Workpiece Alignment.
> Choose No Fiducials
No FiducialsNo Fiducials
No Fiducials.
2. Click on Dispensing Elements on the Program Commands toolbar.
> A Teach Window opens.
3. Click on Weight Control Lines.
> Notice, as shown in Figure 8-3, that the Teach Window has additional text
boxes below the video display specifically for weight control lines.
Figure 8-3
4. Type 20 mg in the Total Weight
Total WeightTotal Weight
Total Weight text box.
> Entering 20 mg means that 20 mg of fluid will be dispensed along the length
of the line you will now define.
5. Move the camera crosshairs to the beginning of the top weight control line on Side
1 of the Tutorial Board.
6. Click on Teach.
7. Move the camera crosshairs to the end of the line.
Customize
d
Dialogs fo
r
Weight-contro
l
Line
Specification