User Manual

Beginning Programming 8-5
Editing the Lines
If you were not satisfied with the lines dispensed, you can simply edit them. This exercise
will teach you how to edit existing lines in a program. For this exercise, you will shift the
lines over and shorten them.
To edit the lines (shift them over and shorten):
1. From the Edit
EditEdit
Edit menu in the Programming Window, select Edit Pattern
Edit PatternEdit Pattern
Edit Pattern.
2. Click on Workpiece
WorkpieceWorkpiece
Workpiece.
The dispensing head will move after your response.
3. Place the cursor on 1 LINE in the program and double-click.
> A Teach Window opens.
4. Use the Position Controls to move the crosshairs to the start of the first shorter line
in the set of shorter lines on the Tutorial Board.
5. Click on Teach.
6. Use the Position Controls to move the crosshairs to the end point of the next line.
7. Click on Teach.
8. Repeat Steps 3 - 7 for the other two lines.
9. Click on Done.
10. Select Dry Run
Dry RunDry Run
Dry Run from the Run
RunRun
Run menu.
The dispensing head will move after your response.
> Watch to see the program run with the lines shifted over and shortened.
11. Select Wet Run
Wet RunWet Run
Wet Run from the Run
RunRun
Run menu.
> Watch as the lines are dispensed.
> Examine the board for quality and accuracy.
This concludes the tutorial on Editing Basic Lines.