User Manual

8-4 Beginning Programming
16. In the Programming Window, click on Run
RunRun
Run and select Dry Run
Dry RunDry Run
Dry Run.
The dispensing head will move after your response.
> Watch the video display as the dispensing head performs the programmed
commands. The camera will act as the needle and follow the lines, but no
dispensing will be performed.
If the lines were “dry dispensed” at an incorrect angle, you may need to re-
program the origin of the board and workpiece angle. Unfortunately, this
means you will need to start over defining this program.
17. In the Programming Window, click on Run
RunRun
Run and select Wet Run
Wet RunWet Run
Wet Run.
> Watch as the lines are dispensed.
> Examine the board for quality and accuracy.
This concludes the tutorial on Basic Lines.