User Manual

Programming Basics 7-15
Figure 7 -4
Figure 7 -5
When using a single fiducial with Orthogonality Tolerance, FmNT calculates the angle of
the corner defined by the calipers. If the corner is within the Orthogonality Tolerance, the
part is considered square and dispensing on the part will be performed. For example, if the
Orthogonality Tolerance is set at 5, and the corner fiducial is determined to be 85-95
degrees, FmNT considers the part to be square. However, if the corner fiducial is less than
85 degrees or more than 95 degrees, FmNT will issue an Orthogonality Tolerance warning
and you can choose to skip the part or redefine the fiducial.
Projection Length
A
pplication Point
Multiple Calipers
Search Length
Calipe
r