User guide

Installation 11

3. Connect the multi-pin male I/O connector of the cable to the Interface Board in the card slot

of the computer.

4. Connect the VDC power connector of the cable to the power manager connector labeled

Auxiliary DC located in the dispensing system lower cabinet.

5. Close the cabinet doors to the dispensing system, install the power cord to the facility, and

power up the dispensing system.

6. You are now ready to install the DriverLINX software.

Item Description

1 Computer Interface Board Slot

2 Multi-Pin I/O Connector

Figure 3-3 FMS Cable Installation to Computer