User guide

Installation 9

To install the Flow Meter:

" NOTE If continuing from previous section, the system should still be shutdown for service. If not

perform a service shutdown as specified in the C-740/C-741 Installation, Operations, and

Maintenance Manual.

1. Install the FMS bracket and flow meter as follows:

a. Use a hex wrench to install two screws and two washers to secure the bracket to the

dispensing system.

b. Use a hex wrench to install two screws and two washers to secure the FMS to the FMS

bracket.

2. Use adjustable wrenches and Teflon pipe tape to install the fluid lines and fittings to the flow

meter as follows:

a. Remove the protective caps from the flow meter orifices.

b. Install the elbow fittings to the flow meter right and left side female orifice.

c. Connect the fluid lines to the elbow fittings making sure of a tight fit.

Item Description Item Description

1 Flow Meter 4 Screws (4)

2 Bracket 5 Hose Line

3 Washers (4) 6 Elbow Fittings (2)

Figure 3-1 Flow Meter Installation