Manual

Programming 5-17
9. Follow the steps below if the pattern has a different Z-height than the product (i.e. fixture
coordinate system), otherwise skip this step. See Figure 5-4.
a. Make sure that a tool whose tip can reach the substrate is selected from the drop down
tool menu and then move the active tool down to the substrate height.
 NOTE If you have a dual toggle system, you should use the tool with the lowest
dispense height, since variations in substrate height will more
dramatically affect that tools coating quality.
b. Click the
Teach Z button.
 The substrate height is now taught.
10. Click
OK.
 The pattern will be created in the Patterns section of the program.
 See 5.9.4 Inserting Program Instructions to insert instructions into the pattern.
11. Close the camera window [
F4] and select a dispensing applicator from the tool drop-down
menu on the Edit Screen.
12. Verify the pattern position by selecting the pattern so that it is highlighted and clicking on
the
GoTo button. See Figure 5-16.
 The active tool should move to the XY pattern origin and the coordinates should display
0,0,Z, where Z is the tool's height above the pattern.
Figure 5-16 Verifying Pattern Position
Pattern
Selected
Pattern
Coordinates
GoTo Button
Active Tool