Manual

5-14 Programming
 The speed limit is set by clicking on Configure > Robot Settings in the Edit Menu and
entering the desired speed limit. See Figure 5-12.
Figure 5-12 Setting the Speed Limit
 NOTE The speed limit does not affect on/off distances or start/stop distances.
Therefore, fluid dispensed with the speed limit feature activated does not
accurately reflect the conditions when the fluid is dispensed at full speed. To
detect the possibility of a collision, the fluid must be dispensed at full speed.
In addition, the ability to negotiate tight curves for continuous path coating
commands may be exaggerated with the speed limit feature activated.
12. Test the completed program by clicking on
Run > Run or pressing the [F9] key.
13. Click on
Save .
14. Place your program in the Product Map so it will be available on the Operator Screen.
See 4.17 Product Map Configuration.