Manual

Configuration and Characterization 4-9
To perform a characterization:
 NOTE Make sure you have selected the proper tool as the pointer in the Edit Screen
(Figure 4-8). This is the tool that will be used to teach the positions. If the system is
configured with a Genie Camera or a Laser Pointer and you are going to use one of
these to teach positions, make sure it is selected.
Figure 4-8 Selected Pointer
1. From the Edit Screen, click on Configure > Tools.
2. Select the tab for the tool to be configured and then click the
Configure button
(Figure 4-9).
 The tabs will vary depending on system configuration.
Figure 4-9 ECXP Tool Configuration
 The Conformal Coating Characterization Wizard dialog box opens (Figure 4-10).