Manual

4-4 Configuration and Characterization
3. Load a board.
4. Place a piece of dilatant compound on the board.
5. Click
Teach Relative in the Tool Configuration window for your selected tool.
 You will be prompted to select a reference tool (Figure 4-3).
Figure 4-3 Selecting a Reference Tool
 NOTE To ensure accurate positioning when teaching coating programs, offsets should
be taught relative to the teaching tool. If a camera or laser pointer is in use,
teach the offset relative to the camera or laser pointer.
6. Click the
to access the drop-down list, select the reference tool, and click OK.
 You will then be prompted to teach the tool reference point (Figure 4-4).