Manual

4-2 Configuration and Characterization

4.4 Tool Configuration

A tool consists of a fluid dispensing applicator and nozzle. The Tool Configuration dialog box allows you

to set the offset for each tool and perform a characterization.

4.4.1 Tool Offset

Tool Offset is the X, Y, and Z distance from the lower tooling pin on the Z-slide (also called the tool

flange, or tool arm) to the tool tip (end of nozzle). See Figure 4-1. The offset for each tool must be entered

into ECXP so that the robot can position the tool tip accurately when running product programs.

WARNING! If Tool Offsets have already been defined and set up in the Tool Library, correct

offsets are displayed in the Tool Configuration dialog box. DO NOT change them

without assistance from your Nordson ASYMTEK representative. Your Nordson

ASYMTEK representative can supply you with the offset coordinates for each tool

used. Coordinates are based on machine configuration.

 NOTE To define offsets for dual applicator systems, see 4.4.1.1 Dual Applicators/Needle

Finder. To define offsets for the optional Laser Pointer, see 4.4.1.2 Laser Pointer.

Item Description

1 Z-Slide (Tool Flange)

2 Dispenser

3 Lower Tooling Pin

4 Tool Tip

Figure 4-1 Tool Offset