Manual

Tour of Easy Coat 3-15

3.8 Setting and Monitoring Fluid Air Pressure

Fluid air pressure is set and monitored through ECXP software-controlled electronic regulators. A

complete process history can be maintained in ECXP log files for these critical parameters. Fluid pressure

can be adjusted from both the ECXP Operator and ECXP Edit Screens.

To adjust the fluid pressure (Operator Screen):

1. Click on the

Controls tab at the bottom of the Operator Screen.

2. Click on the desired

Tool tab.

 The tabs will vary depending on which tools have been configured for the system.

3. To use the slider bar (Figure 3-9):

a. Click on the

Slider tab.

b. Center the mouse pointer on the slider bar. Click and hold the left mouse button while

moving the slider bar. Moving it to the right will increase the pressure and to the left

will decrease the pressure.

 The fluid pressure is displayed above the slider bar.

4. You can also type in the desired fluid pressure, by typing over the current fluid pressure

value displayed above the slider bar. Press the [Tab] key to finalize the entry.

Item Description

1 Tool Tab

2 Current Air Pressure Value

3 Slider Bar

Figure 3-9 Adjusting the Fluid Pressure