Manual

Installation 2-5
3. Enter the customer name and machine description when prompted and click OK.
 ECXP will prompt you to select your system. See Figure 2-3.
Figure 2-3 System Configuration
4. Select your system and click OK.
5. You will then be prompted to answer the following questions.
 NOTE Questions will vary depending on system series and configuration and
responses to previous questions.
a. Does this system have the Automatic Material Changeover option?
b. Does this system have a heated, circulating fluid system?
c. Does this system use a scale to sense the fluid level?
d. Does this system have a low fluid sensor?
e. Does this system have fan width control?
f. Does this system have a flow meter option?
g. Does this system have a needle finder?
h. Does this system have an ID System (barcode scanner)?
i. Does this system have dual applicators (but not dual simultaneous)?
 You will be prompted to define your tools. See 2.5.1.2 Tools Configuration.
j. If you selected a conveyorized system, you will prompted to define your conveyor
setup. See 2.5.1.3 Conveyor Configuration.