Manual

Appendix B- Instruction Properties B-13
Repeat
Description: Instructions between Repeat and End instructions are executed a set number of times.
Creates a loop between the Repeat instruction and the End instruction.
Syntax:
REPEAT <number of times>
[Instructions]
END
Properties:
Property Description
Number of Times
Number of times to execute loop.
Rotate Home
Description: Rotates the tool to its origin. Only supported by Select Coat 4-axis or 5-axis dispenser.
Properties:
Property Description
Tool
Default = Tool displayed in Current Tool Selector when instruction created. Tool
to use for this instruction. Click on List button to select different tool.
Rotate Tool
Description: Rotates the tool in 90-degree increments. Only supported by the Select Coat 4-axis or
5-axis dispenser.
Properties:
Property Description
Rotate (deg)
Number of degrees to rotate the tool. Rotation is in 90-degree increments. If a
value less than 90 but greater than 45 is entered, the tool is rotated 90
degrees. If a value less than 45 degrees is entered, the tool is not rotated. The
rotate cycle is absolute, not relative. For example, if a pattern requires that the
tool be rotated 90 degrees, then to 180 degrees, the first instruction must have
a value of 90 and the second a value of 180.
Tool
Default = Tool displayed in Current Tool Selector when instruction created. Tool
to use for this instruction. Click on List button to select different tool.