Instruction Manual

Configuration and Characterization 4-3
To define Tool Offsets:
1. Click on
Configure > Tools from the Edit Screen menu bar.
 The Tool Configuration dialog box opens (Figure 4-2).
WARNING! If Tool Offsets have already been defined and set up in the Tool Library,
correct offsets are displayed in the Tool Configuration dialog box. DO NOT
change them without assistance from your Asymtek representative. Your
Asymtek application engineer can supply you with the offset coordinates for
each tool used.
Figure 4-2 Tool Configuration Dialog Box
2. Select the desired tool tab.
 NOTE(s) Some tools have multiple soft-tools (software tools) for a single physical tool. For
example, the SC-300 has five soft tools for one physical applicator. It is only
necessary to change the offsets for one of the soft-tools. Offsets for the remainder of
the soft-tools automatically update.
If you are teaching the offsets for a tool that toggles or otherwise actuates
pneumatically, make sure that it is selected from the drop down tool menu and that it
is rotated/tilted to 0 degrees. Selecting from the drop down menu will ensure that the
tool toggles down.