Instruction Manual

Installation 2-5
4. Does this applicator have a nozzle extension?
5. Will this tool control dual applicators?
6. One applicator has been configured. Do you need another applicator?
7. Will the tool use a needle finder?
8. Do you require the LowAir tool? (Swirl Applicator only)
9. Do you require the HighAir tool? (Swirl Applicator only)
10. Does the camera have attached lighting? (Answer yes if you have pattern recognition,
otherwise answer no).
2.5.1.3 Conveyor Configuration
If you selected a conveyorized system, you will be prompted to answer the following questions: :
 NOTE Questions will vary depending on system series and configuration and responses
to previous questions.
1. Is your conveyor left to right?
2. Does your conveyor have a prequeue?
3. Does this conveyor have clamps or pins in the dispense station?
4. Is there a sensor to detect that the product pins or clamps are engaged?
5. Do you have an inverter?
6. Is your inverter upstream?
2.5.1.4 ID Systems Configuration
If your system has an ID system (barcode scanner), you will be prompted to select your ID system.
See Figure 2-4.
Figure 2-4 ID Systems Configuration
 NOTE After you have responded to all of the questions, the ECXP Operator Screen opens and
you are ready to begin your session.