Instruction Manual

Installation 2-3
2.5 ECXP Configuration
The first time ECXP is run, a setup procedure runs, asking you to define your system hardware.
Responses to each question are written to the ECW.INI file. If you change your system hardware or
reinstall the software, use the Reconfigure feature to re-run the setup procedure. See 2.5.2 Reconfigure.
 NOTE In most cases, ECXP arrives already installed and configured for your dispensing system
from the Asymtek factory.
2.5.1 Initial Setup Procedure
 NOTE This procedure runs the first time you start ECXP. To reconfigure system hardware, see
2.5.2 Reconfigure.
2.5.1.1 System Configuration
1. Double-click the
ECXP icon on the Windows desktop to start ECXP.
 ECXP will prompt you to select your system. See Figure 2-1.
Figure 2-1 System Configuration
2. Select your system and click OK.
3. You will then be prompted to answer the following questions.
a. Does this system have the Automatic Material Changeover option?
b. Does this system use a scale to sense the fluid level?
c. Does this system have a low fluid sensor?
d. Does this system have a heated, circulating fluid system?
e. Does this system have fan width control?
f. Does this system have a flow meter option?
g. Does this system have a needle finder?