User guide

vi Table of Contents
4.10 Beacon Configuration ............................................................................................................4-14
4.11 Fan Width Configuration ........................................................................................................4-16
4.11.1 FWC Sensor Setup...................................................................................................4-19
4.12 Needle Finder Configuration..................................................................................................4-20
4.12.1 Single Needle Applicator: .........................................................................................4-20
4.12.2 Dual Applicators (Only One Fits in Needle Finder):..................................................4-21
4.12.3 Tolerances ................................................................................................................4-21
4.13 Bar Code Scanner Configuration...........................................................................................4-22
4.13.1 PSC5312 (Hand-Held) Scanner Configuration.........................................................4-22
4.13.2 MS810 (Fixed Mount) Scanner Configuration ..........................................................4-22
4.13.3 Bar Codes .................................................................................................................4-23
4.14 Reconfiguring System Hardware ...........................................................................................4-24
4.15 Production Configuration .......................................................................................................4-25
4.15.1 Setting Idle Timers.................................................................................................... 4-25
4.15.2 Setting Periodic Timers.............................................................................................4-25
4.15.3 AutoStart ................................................................................................................... 4-27
4.15.4 Homing......................................................................................................................4-27
4.16 Log Configuration...................................................................................................................4-27
4.16.1 Log Files ...................................................................................................................4-27
4.17 Product Map Configuration .................................................................................................... 4-28
4.17.1 New Group................................................................................................................4-29
4.17.2 New Part ...................................................................................................................4-29
4.18 Maintenance Manager ...........................................................................................................4-30
4.18.1 Maintenance Manager Configuration .......................................................................4-30
4.18.2 Adding/Deleting Maintenance Procedures ...............................................................4-30
4.19 Custom Buttons .....................................................................................................................4-33
5 Programming ....................................................................................................................................5-1
5.1 Overview ..................................................................................................................................5-1
5.2 Safety First...............................................................................................................................5-1
5.3 Programs .................................................................................................................................5-1
5.3.1 Product Programs....................................................................................................... 5-1
5.3.2 Opening a Product Program .......................................................................................5-2
5.3.3 Macro Programs .........................................................................................................5-2
5.3.4 Opening a Macro Program .........................................................................................5-3
5.4 Patterns....................................................................................................................................5-3
5.4.1 Main Pattern................................................................................................................ 5-4
5.5 Mask Regions ..........................................................................................................................5-4
5.5.1 Coating an Area Inside a Mask Region ......................................................................5-4
5.5.2 Inherited Mask Regions .............................................................................................. 5-4
5.6 Procedures...............................................................................................................................5-4
5.6.1 Reserved Procedures ................................................................................................. 5-4
5.7 Reference Frames ...................................................................................................................5-8
5.7.1 Base Frame ................................................................................................................5-8
5.7.2 Product Frame ............................................................................................................5-8
5.7.3 Pattern Frame ............................................................................................................. 5-9