User guide

3-12 Tour of Easy Coat
3.6.4 Edit Screen Tabs
The Edit Screen is divided into a series of tabs. Tabs will vary depending upon your system configuration.
Basic groups include:
• Conformal Coating
• Control
• General
• Motion
Depending on your system hardware, additional tabs include:
• A201 Conveyor
• Inverter
• Fan Width Control
• Needle Finder
• A201 Robot
Each tab contains related buttons to assist you with inserting program commands into your conformal
coating program. Basic tabs are shown in
Figure 3-7. Tabs may vary depending on system configuration.
Refer to Section 5 - Programming for detailed information.
Figure 3-7 Edit Screen Tabs