User guide

Installation 2-5
2.5.1.3 Conveyor Configuration
If you selected a conveyorized system, you will be prompted to answer the following questions about the
conveyor.
1. Is your conveyor left to right?
2. Is this a chain conveyor?
3. Does this conveyor have clamps or pins in the dispense station?
4. Is there a sensor to detect that the product pins or clamps are engaged?
5. Do you have an inverter?
6. Is your inverter upstream?
7. Is there an entry sensor on the conveyor?
ID Systems Configuration
If your system has an ID system (barcode scanner), you will be prompted to select your ID system.
See Figure 2-3.
Figure 2-3 ID Systems Configuration
" NOTE After you have responded to all of the questions, the ECXP Operator Screen opens and
you are ready to begin your session.
WARNING! Do not edit the ECW.INI file unless it is absolutely necessary and you have been
trained to do so. An error in this file can cause your system to run erratically or
not at all. Contact your Asymtek representative before editing this file.