User guide

2-4 Installation
2.5.1.2 Tools Configuration
After you have defined your system, you will be prompted to define your tool (fluid applicator). See
Figure 2-2.
Figure 2-2 Tools Configuration
Depending on the applicator and options selected, you will be prompted to respond to some or all of the
following questions.
1. Does this applicator have tilt?
2. Does this applicator have rotate?
3. Does this applicator have incremental rotate (0, 90, 180, and 270 degrees)?
4. Does this applicator have a nozzle extension?
5. Will this tool control dual applicators?
6. One applicator has been configured. Do you need another applicator?
7. Will the SC-300 Swirl Tool use a needle finder?
8. Will the SC-300 Bead Tool use a needle finder?
9. Will the SC-300 Monofilament Tool use a needle finder?
10. Do you require the LowAir tool? (Swirl Applicator only)
11. Do you require the High Air tool? (Swirl Applicator only)