User guide

Installation 2-3
2.5 ECXP Configuration
The first time ECXP is run, a setup procedure runs, asking you to define your system hardware.
Responses to each question are written to the ECW.INI file. If you change your system hardware or
reinstall the software, use the Reconfigure feature to re-run the setup procedure. See 2.5.2 Reconfigure.
" NOTE In most cases, ECXP arrives already installed and configured for your dispensing system
from the Asymtek factory.
2.5.1 Initial Setup Procedure
" NOTE This procedure runs the first time you start ECXP. To reconfigure system hardware, see
2.5.2 Reconfigure.
2.5.1.1 System Configuration
1. Double-click the
ECXP icon on the Windows desktop to start ECXP.
! ECXP will prompt you to select your system configuration. See Figure 2-1.
Figure 2-1 System Configuration
2. Select your system configuration and click OK.
3. You will then be prompted to answer the following questions.
a. Does this system have a low fluid sensor?
b. Does this system have fan width control?
c. Does this system have a flow meter option?
d. Does this system have a needle finder?
e. Does this system have an ID System (barcode scanner)?
" NOTE Questions will vary depending on answers to previous questions. ECXP menu
choices may also vary depending on system configuration.