Manual

Programming 5-31
7. Click OK.
8. Undock the Graphic Display as described in 5.13.5.4 Undocking/Redocking.
9. Click on the “Side 1” pattern.
10. Click on the Conformal Coating tab and then on the
Area Coat button.
! The Graphics Display reappears.
11. Move the cursor to the start point of the area on the graphics image to be coated and press the
<CTRL> key and left-click the mouse.
12. Move the cursor to the end point and press <CTRL> left-click again.
13. Repeat Steps 10 through 12 and coat another section of the board.
14. Your screen should look similar to the one in Figure 5-30.
Figure 5-30 Area Coat Program Using Graphics Display
15. Click on Save and enter a program name.
Coated
Area
Coated
Area