Manual

Programming 5-15
" NOTE When you create an instruction, the tool shown in the Current Tool Selector is entered
into the tool property of the instruction. The current tool tip coordinates are entered into
the first set of coordinate properties (Begin X and Y properties) with the exception of the
Spot instruction. See Figure 5-11.
1. To change tools, click on
List button in the Tool Property field and select a new tool.
2. To change coordinates, move the tool tip to the pattern starting point and click the
Teach Field button. Teaching the first set of coordinates activates the second set,
if required.
3. Complete the Properties section and click on
Save .
" NOTE Highlight the pattern to see the pattern properties. Highlight the instruction to see the
instruction properties. Refer to Appendix B for a description of all instruction properties.
Figure 5-11 Pattern and Instruction Properties
Instruction
Properties
Pattern
Properties