Manual

Programming 5-11
" NOTE Every program contains a Main Pattern, which consists of an Edit Frame and a Mask
Regions pattern. See Figure 5-7.
Figure 5-7 Untitled Program
7. Make sure the Main Pattern Edit Frame was calculated correctly:
a. Expand the properties of the Main Pattern, then click on the Main Pattern Edit Frame.
b. Click on the
GoTo button.
! The applicator should travel to the front left corner of the product or pallet if the
length and width and Fixture Configuration is correct.
! To correct the length and width, click on the Program Name at the top of the Tree
View. The length and width will be displayed in the Property List. See Figure 5-5.
" NOTE The Main Pattern Edit Frame X, Y, and Z properties are automatically calculated
and should NEVER BE TAUGHT. They should always be displayed as 0,0,0.
8. To save the program:
a. Click on
Save or select File > Save Product Program As from the menu bar.
b. Enter a program filename.
c. Select a folder to save it in.
d. Click on
OK.
9. Create the patterns required to coat your product, inserting instructions into the patterns as
needed. See 5.9.3 Creating a Pattern.
10. Enter Place Pattern instructions in the Main Pattern to execute the patterns.
See 5.9.6 Placing Patterns.
11. Test each pattern by selecting it and clicking on
Run > Run Pattern/Procedure or by
pressing the
[F6] key.
12. Test the completed program by clicking on
Run > Run or pressing the [F9] key.
13. Click on
Save .
14. Place your program in the Product Map so it will be available on the Operator screen.
See 4.10 Product Map Configuration.