Manual

4-14 Configuration and Characterization
4. Click on the Teach Field button.
! The value entered is the current Z coordinate of the tool tip, and should be negative.
! If you wish to edit this value manually, select the property field and enter a new value.
4.7.4 Fan Width Control
If your system is equipped with the optional Laser Fan Width Control feature, you will need to perform a
Fan Width Setup. For additional information, refer to the manual for your Fan Width Control System or
contact your Asymtek representative.
4.7.5 Fan Width Configuration
After ECNT has been installed and the system hardware has been defined, you will need to perform a Fan
Width Setup. The Fan Width Configuration Window is shown in Figure 4-11. Menu options are described
in Table 4-3.
Figure 4-11 Fan Width Control Configuration Window