Manual

4-10 Configuration and Characterization
4.7 Hardware Configuration
4.7.1 Conveyor Configuration
To configure the conveyor:
1. Click on
Configure > Conveyor Settings from the ECNT Edit Screen.
! The Conveyor Settings dialog box shown in Figure 4-9 opens.
" NOTE The Conveyor Settings dialog box also contains Inverter configuration settings.
See 4.7.2 Inverter Configuration later in this section.
2. Enter the desired property values.
! See Table 4-1 for a description and default value for each property.
3. Click
OK when done.
Figure 4-9 Conveyor Settings Dialog Box