Manual

4-6 Configuration and Characterization

! The Wizard will now apply three stripes of material to the test area (See Figure 4-5).

Figure 4-5 Material Characterization

8. You will be prompted to teach the coordinates of the test area.

a. Teach the stripe with the best starting accuracy.

! If none are exact but one stripe starts too soon and the next too late, teach between the

two stripes. The Wizard interpolates the values of the two.

b. Teach the stripe with the best ending accuracy.

! If none are exact but one stripe ends too soon and the next too late, teach between the

two stripes. The Wizard interpolates the values of the two.

9. Enter the stripe width.

! The Wizard applies three more stripes to the test area.

10. Check the starting and ending points of the second three stripes. If they are not accurate, rerun

the characterization, making adjustments as necessary to obtain the best results.

11. The settings will be displayed for your approval. The only variable you can change is the

stripe width. To change any other settings, you will have to rerun the characterization.

TIP To perform a characterization from the ECNT Edit Screen, click on Configure > Tools.

The Tool Configuration dialog box opens. Select the tab for the tool you wish

characterize, then click the

Configure button.

Desired Start Desired End

3 passes

Stripe with Best

Ending Accuracy

Stripe with

Best Starting

Accuracy

3 passes