Manual

Configuration and Characterization 4-5
2. Click Clear Positions.
! If you have performed a characterization before, the old test area coordinates are used
unless you clear them.
3. Click
Next.
4. Teach the substrate height.
a. Place a characterization sheet in the workcell. See Figure 4-4.
b. Install a nozzle on the Fluid Dispensing Applicator and lower the tool until the tip just
touches the characterization sheet (substrate).
ELECTRONICS BUSINESS GROUP SELECT COAT
®
SYSTEM
SEQUENCE NUMBER:
OPERATOR:
DATE:
TYPE MATERIAL:
MIX MAT./SOLV.:
ZAHN 2 TIME:
NOZZLE:
MICROADJUST:
MATERIAL TEMP.:
FLUID PRESSURE:
Z HEIGHT:
COATING VELOCITY:
AIR MOTOR PRESSURE:
COAT ON TIME:
COAT OFF TIME:
ML THICKNESS:
COMMENTS:
V-0432-001A
143817
Figure 4-4 Characterization Sheet
5. Enter the dispense height.
! The following variables should be considered:
- Height of tallest component to be coated
- Width of coating stripe
- Coating material flow rate and viscosity
- Coating stripe overlap
6. Enter the desired rotate position (for applicators equipped with rotate and cross-cut nozzles).
7. Enter the desired dispense speed.