Manual

Tour of Easy Coat 3-11
Table 3-4 Edit Screen Toolbar Commands (Continued)
Button Description
Create Mask Region
Allows you to create a new Mask Region. A Mask Region is an area of the
board that will not be coated. Refer to Section 5 - Programming for detailed
instructions.
Run Runs the loaded program.
Step
Steps through the loaded program. Each click of the button performs one
instruction.
Pause
Pauses the current program. If a program is not running, this choice will be
grayed-out (non-functional).
Stop
Stops the current program. If a program is not running, this choice will be
grayed-out (non-functional).
Silence Alarm
Click to silence an alarm activated by a fault.
Clear Faults
Click to clear fault(s). Only clearable faults, such as a board failing to load, can
be cleared. Faults generated by hardware failures, such as Controller Offline,
cannot be cleared with this button. If the problem that generated the fault(s) is
not corrected, faults will reoccur.
Teach
This button is used in the programming process to teach the robot’s XYZ
location for dispensing purposes. Refer to Section 5 - Programming for detailed
instructions.
Go To
Moves the Tool tip to the active XYZ coordinates of a selected instruction or to
the coordinates of a selected pattern or procedure’s Edit Frame.
Begin Idle
Executes the Begin Idle procedure in the currently loaded product or macro
program. Typically, the Begin Idle procedure places the nozzle in a solvent
bath.
End Idle
Executes the End Idle procedure in the currently loaded product or macro
program. The End Idle procedure typically purges the solvent from the nozzle
before resuming production.
Periodic
This button executes the periodic procedure in the currently loaded product or
macro program. Periodic behavior is defined by the instructions in the periodic
procedures. These procedures allow a sequence of operations to be performed
periodically during production.
Go To Front Moves the tool arm to the front-center of the workcell.
Z-Home
Moves the tool arm to the top of the Z-axis.
Load
Click to load a product into the fixture. Only present when ECNT is configured
for a conveyor.
Unload
Click to unload a product from the fixture. Does not move the product to the
downstream machine. Only present when ECNT is configured for a conveyor.